![]() Service-module wlan-ap 0 bootimage autonomousĭescription Service module interface to manage the embedded APĭescription Internal switch interface connecting to the embedded APĪccess-list 100 permit ip 10.10.10.0 0.0.0.255 192.168.1.0 0.0.0. Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds: of red lines with: memory ipsec, error phase 1 negotiation failed due to time up 127. 17:57:37: INFO: accept a request to establish IKE-SA: xx.xx.xx.24ħ1.32.110.24 97.77.166.134 MM_NO_STATE 0 ACTIVE (deleted)īut nothing else comes out and dont know how to see the log for 891 to see the errors The test will fail because of the exception, but failing is the. 17:57:23: ERROR: Phase 2 negotiation failed due to time up waiting for phase1. 17:57:23: ERROR: Invalid SA protocol type: 0 17:56:52: ERROR: Ignore information because the message has no hash payload. 17:56:52: INFO: Beginning Identity Protection mode. 17:56:52: INFO: Initiating new phase 1 negotiation: xx.xx.xx.134xx.xx.xx.24 17:56:52: INFO: Configuration found for xx.xx.xx.24. 17:56:23: WARNING: schedular is already scheduled for SA creation for remote: "xx.xx.xx.24" 17:56:23: ERROR: Failed to attach schedSaCreate in IKE configuraion Ip nat inside source list 1 interface Dialer1 overloadĪccess-list 1 permit 10.10.10.0 0.0.0.255Īccess-list 100 remark maptest1 category=4Īccess-list 100 permit ip 10.10.10.0 0.0.0.255 192.168.1.0 0.0.0.255Ĭrypto isakmp key Testingkey address xx.xx.xx.134Ĭrypto ipsec transform-set test1 esp-3des esp-md5-hmac 18:17:00: WARNING: schedular is already scheduled for SA creation for remote: "xx.xx.xx.xx" 18:17:00: ERROR: Failed to attach schedSaCreate in IKE configuraionĬrypto isakmp key Testingkey address xx.xx.xx.xxxĬrypto ipsec transform-set test1 ah-md5-hmac esp-3des ![]() 18:16:42: ERROR: Phase 2 negotiation failed due to time up waiting for phase1. 18:16:42: ERROR: Invalid SA protocol type: 0 ![]() 18:16:11: ERROR: Ignore information because the message has no hash payload. 18:16:11: INFO: Beginning Identity Protection mode. 18:16:11: INFO: Initiating new phase 1 negotiation: xx.xx.xx.xxxx.xx.xx.xx i was following documentation and tutorial around internet but still no luck.my plan is connecting fortigate to Mikrotik side B using vpn ipsec tunnel. 18:16:11: INFO: Configuration found for xx.xx.xx.xx. I am new in fortigate but i have problem i tried using ipsec fortigate to mikrotik side B using ipsec. the error that i get in the rv120 isĠ12-08-02 18:15:35: ERROR: Phase 1 negotiation failed due to time up for xx.xx.xx.xx. I thinking it might be my access list on the 891. I im doing a site to site vpn for the first time on a 891 to a rv 120 (gui) but it doesnt connect.
0 Comments
Leave a Reply. |